The practical points
Feeder architecture and spindle/headstock configuration determine whether full-length, magazine-length, or short-loader stock is appropriate.
State usable minimum and maximum length, not only a nominal cut length, when pusher engagement or remnant control matters.
Chamfer, burr, end squareness, bundle orientation, packaging, and transit damage can affect loading even when the length is correct.
Treat 36, 48, 72, and 144 inches as common examples—not universal standards—and confirm the actual machine and feeder requirement.
Bar-feeder cut-length worksheet
Use this worksheet to carry the machine-side assumptions into the material request. Leave a field blank when it is genuinely open; do not replace a required print, customer, or machine value with a guess.
Check the plan before sending
- The target length sits inside the actual loader or feeder window.
- The selected length supports the intended part count and safe remnant.
- Lead and pusher ends are defined separately when they differ.
- Diameter, straightness, surface, cleanliness, and liner fit are not being assumed from nominal size.
- Quantity is stated as pieces, pounds, release schedule, or all three where useful.
- Heat-lot segregation and packaging are stated if mixing would disrupt receiving or production.
Planner scope: This worksheet organizes the request. The machine manual, actual setup, print, purchase order, accepted quote, and order acknowledgement remain controlling.
Put it on the purchase description
If diameter tolerance, straightness, roundness, surface finish, hardness, chemistry, origin, or documentation can affect acceptance or machining performance, state it explicitly. A familiar grade name is not a complete purchasing specification.
Reviewed by the Exact Bar technical sourcing team. Last reviewed August 17, 2026. The review checks primary sources, separates grade-specific claims from general guidance, and identifies what still requires machine, print, source, or lot validation. This is procurement guidance—not permission to substitute material or bypass the drawing, purchase order, accepted quote, order acknowledgement, incorporated specifications, or machine-specific validation.